Skip to content

Conversation

timvdalen
Copy link

When trying to get my slicer profiles to match the results from the retraction calibration, I missed that the flow rate in Simplify3D was set to 0.9 (as per the note on the Slicer Flow Calibration page).
It took me a long time to figure out that this was the only (and crucial) difference between my profile and the site, so I'm documenting it in the troubleshooting section.

I put it in between Travel acceleration and Linear advance, but perhaps it should be even higher.

Sign up for free to join this conversation on GitHub. Already have an account? Sign in to comment
Labels
None yet
Projects
None yet
Development

Successfully merging this pull request may close these issues.

1 participant